Skip to content

Installation

Mounting#

The MIVO Connect is designed for indoor use and must be mounted in an electrical enclosure with a suitable IP rating and supported on a DIN-Rail. The enclosure must cover the power terminals and the expansion connector.

The product must be mounted vertically with terminal connector 1 and 2 (in the Product Description) facing upwards. No other rotation is allowed.

Always allow good ventilation clearances: 40mm above and 20mm below, to prevent overheating. Keep other heat-generating devices more than 10mm away from this product.

Mounting Instructions

  1. Tilt the product up and place the topmost latches on top of the DIN-Rail.
  2. Tilt the product down until the bottom latch snaps into place. If necessary, use a small screwdriver to pull the latch (item 16 in the Product Description) down.

Removal Instructions

Make sure power is disconnected before proceeding.

  1. Disconnect all cables.
  2. Pull the bottom latch (item 16 in the Product Description) down with a screwdriver and tilt the product upwards.
  3. Lift the device up and then move the product straight out.

Connections#

MIVO Connect#

The expansion port is designed for up to 10 expansions on every MIVO Connect.

Connection Instructions

  1. Make sure the power to the system is disconnected.
  2. Connect the wider of the two cable connectors to the connector labeled “Expansion In” on the Extender and push firmly until the latch engages with a click.
  3. Connect the other end of the cable to the previous Expansion or Expansion Out port in the same way.
  4. Repeat the process for all Extenders.

Disconnect Instructions

  1. Make sure the power to the system is disconnected.
  2. Hold down the connector latch and pull the connector straight out.

Wireless M-BUS#

Connection of Wireless M-Bus Antenna

  1. Screw the cable connector nut clockwise onto the expansion antenna connector.
  2. Tighten the connector with a small wrench. The recommended torque is 0.3Nm, with a maximum of 0.5Nm.

Warning! Too high torque will permanently damage the expansion.

Disconnection of Wireless M-Bus Antenna

  1. Screw the connector nut counterclockwise until the connectors are separated.