Skip to content

Installation

Mounting#

The MIVO Connect is designed for indoor use and must be mounted in an electrical enclosure with a suitable IP rating and supported on a DIN-Rail. The enclosure must cover the power terminals and the expansion connector.

The product must be mounted vertically with terminal connectors 1 and 2 (see the Product Description) facing upwards; no other rotation is allowed. Always allow adequate ventilation clearances—40 mm above and 20 mm below the device—to prevent overheating. Keep other heat-generating devices at least 10 mm away from this product.

Mounting

  1. Tilt the product up and place the topmost latches on top of the DIN-Rail.
  2. Tilt the product down until the bottom latch snaps into place. If necessary, use a small screwdriver to pull the latch (item 16 in the Product Description) down.

Removal

Ensure power is disconnected before proceeding.

  1. Disconnect all cables.
  2. Pull the bottom latch (item 16 in the Product Description) down with a screwdriver and tilt the product upwards.
  3. Lift the device up and then move the product straight out.

Connections#

MIVO Connect#

Connection

  1. Make sure the power to the system is disconnected.
  2. Connect the wider of the two cable connectors to the connector labeled “Expansion In” on the Extender and push firmly until the latch engages with a click.
  3. Connect the other end of the cable to the previous Expansion or Expansion Out port in the same way.
  4. Repeat the process for all Extenders.

Disconnection

  1. Make sure the power to the system is disconnected.
  2. Hold down the connector latch and pull the connector straight out.

M-bus#

Connection of M-Bus Cables

  1. Peel 8 mm of insulation from the cables to be connected.
  2. Push down the orange button of the terminal to which you want to connect the wire and keep it pressed while inserting the cable at a 45° angle.
  3. Once the cable is inserted, release the button and proceed with the next terminal.

Disconnection of M-Bus Cables

  • Push down the orange button and hold it while pulling the cable out.